I am now experiencing all sorts of power issues... After I installed Corsair link it started giving me warnings... "warning +3.3v 0.00v"... "warning +5v 1.27v". What is going on? I figured my 900w PSU could handle my components. Was I wrong? Will my PSU burn up? Will it damage any of my other components? If so, what PSU would be advisable?
Look below for my current setup.
More about :experiencing voltage warnings installing h80i ing 2ghz
Do you have a corsair power supply with corsair link(looks to be ANTEC)?
If not, ignore it. If you have 3.3 @ 0 and +5 at 1.27, your system would instantly crash.
Every thing USB runs from the 5 volt lines so you would know if they got that low.
Nope, I don't have a Corsair power supply. It is an Antec and I am only using the Corsair Link software so I can monitor my H80i. I don't have the physical module. I was wondering why it wasn't crashing... so is it just the software getting incorrect readings? Also, my Corsair H80i is running off USB 2.0 on the motherboard. Is it possible the warnings are about the H80i not getting enough power?
I would contact Corsair support to see if they have another version of the software for you to try then.
If you disconnect the USB, does it all go full speed? if it does, you may be able to connect the fans to your motherboard and let it deal with the speed. Just remember to still leave the pump connected to the power supply(if it does not run things get bad real fast.).