No boot or image, pls help!

Toggle sidebar Toggle sidebar
A

Adrian Rabben

Honorable
Apr 18, 2013
4
0
10,510
I've just built my first build, and I need some help.
I don't get any image (or signal) at all!

I have the following component:

Motherboard: Asus P9X79 Deluxe
Cpu: Intel I7 3930K
GPU: Geforce GTX Titan
RAM: 4x4GB Kingston Beast 2400mhz
PSU: NZXT 750w gold
CPU Cooler: Corsair H110
Chasis: CM Stryker

When I turn my computer on the DRAM kight is lit, and is stable (always on).

What I've tried so far:

- To push the memOk button
- Clear cmos
- Taken the mb battery in and out
- Made sure that all the RAM pins are in
- I've also tried to use other lower frequency ram
- Made sure all connections are correct

Please help me!
 
Sort by date Sort by votes
A

avjguy2362

Honorable
Jun 21, 2012
732
0
11,360
Your MB has the four LED's for CPU, Ram, GPU and HD. Are any of the those LED lit up? Make sure the TPU and EPU switches are off. They won't work properly until windows is loaded and you have the ASUS AI suite installed. ( I made that mistake with a different ASUS board and somehow it locked it from booting and ASUS sent me another and then I installed the software and everything is fine ) IS the 8 pin PS connector connected?
 
Upvote 0 Downvote
A

avjguy2362

Honorable
Jun 21, 2012
732
0
11,360
I was just reading your manual. Does your MEM OK button have a light on it?? ( "When I turn my computer on the memOK light turns on, and is stable (always on).") The only reason I ask is that your DRAM LED is right next to your MEM OK button. IF it is the DRAM light that is lit up and not the MEM OK button, then it is telling you that your RAM is not being read! ALL of these four indicator lights should come on briefly at POST and then each one turns off as the respective component is detected.
 
Upvote 0 Downvote
A

Adrian Rabben

Honorable
Apr 18, 2013
4
0
10,510


Yes, it's the DRAM light that's lit, so I guess the RAM is not being read, any idea what I can do?

Thanks for the answer btw! :D
 
Upvote 0 Downvote
A

Adrian Rabben

Honorable
Apr 18, 2013
4
0
10,510


Hi,

Yes, I just made sure they were properly pushed in. Did not work :(
Want to add that I get the error message 0C.
Thanks for the tip anyway!! :D
 
Upvote 0 Downvote
You must log in or register to reply here.

TRENDING THREADS

Latest posts

Moderators online

Share this page

COMPANY
RESOURCES
FOLLOW
Top Bottom