Hey all,
I recently purchased an Arctic Twin Turbo II cooler for my GTX 680 FTW card, as it was running pretty hot already and Summer is almost here. All the reviews have stated that the instructions were difficult and I can confirm that they are. The cooler is so generalized that it is difficult to determine what goes where. I was hoping someone could take a quick look at the instructions and clarify what step 4 means: "Apply the insulation tape onto the circuit components in order to prevent short circuit caused by RAM and VR heatsink interference." Where does this tape go? I don't want to fry my card! Also, if anyone who has done this with a 680 is reading this and happens to have a picture of where the heatsinks go that would be great so I could double check. It's my first time doing this. Thanks.
-Justin
DIRECTIONS: http://www.arctic.ac/fileadmin/att2/manual_en.pdf
I recently purchased an Arctic Twin Turbo II cooler for my GTX 680 FTW card, as it was running pretty hot already and Summer is almost here. All the reviews have stated that the instructions were difficult and I can confirm that they are. The cooler is so generalized that it is difficult to determine what goes where. I was hoping someone could take a quick look at the instructions and clarify what step 4 means: "Apply the insulation tape onto the circuit components in order to prevent short circuit caused by RAM and VR heatsink interference." Where does this tape go? I don't want to fry my card! Also, if anyone who has done this with a 680 is reading this and happens to have a picture of where the heatsinks go that would be great so I could double check. It's my first time doing this. Thanks.
-Justin
DIRECTIONS: http://www.arctic.ac/fileadmin/att2/manual_en.pdf