NAT Setup with DLink 605L cloud router

rockstar_7

Distinguished
Nov 22, 2011
249
0
18,710
I've been trying to figure out how run all my devices using one IP, since my ISP is limited to just 5 IP connections...

I'd be grateful if someone would be kind enough to guid me through the steps setting NAT up on my DLink 605L Cloud router -- f.w. 1.14 -- Latest firmware.

Thanks in advance! :D

P.S. The manual doesn't help..
P.P.S. Wireless mode is set to 'Wireless Router' and not 'Access point'. or 'WDS'
 
Solution
That is very strange. That is the default setting. Maybe you changed something you do not remember. If you can't figure it out I would wipe it back to factory and start all over.

you could try a site like www.whatismyip.com and see what it says your devices have
I suspect you are not stating your problem correctly. Most router you have to do nothing. By design NAT is allow sharing of a single IP by multiple machines. Not sure what you mean by 5 ip connections. I have never heard of a limitation like that. It it unlikely they only allow you to have 5 open sessions since a single web page load will open many more than that with a single click. They are very short term but it is very easy to get 20-30 at a time when there are lots of images on a page.
 

rockstar_7

Distinguished
Nov 22, 2011
249
0
18,710


here's what i meant: How do i run all my Wireless devices with one Ip addresS (Many-to-One NAT)? At the moment my router is not doing that. and if it is, how can i find out?
 
That is very strange. That is the default setting. Maybe you changed something you do not remember. If you can't figure it out I would wipe it back to factory and start all over.

you could try a site like www.whatismyip.com and see what it says your devices have
 
Solution

rockstar_7

Distinguished
Nov 22, 2011
249
0
18,710


It's working, verified! But, i hate my ISP for making it as an excuse... my internet is still suffering. (ISP: Du (Etisalat), Dubai, UAE)