First off, a note to the moderators:
Since this might be the wrong place to post this (I'm not sure if it fits under the "systems," category), you are free to move it to its proper location, and I apologize, I tried to use my best judgment.
Moving on to the question, because I did not buy a modular power supply, I have a huge wad of cables, and I have for the most part, successfully hid them away, but this results in a VERY tight fit. There's a slightly noticeable bulge on the thin metal side cover (just to say that I'm not bending 5 feet thick blocks of steel or anything).
Is alright, or if I should just revert back to the clunky wire flooded set-up I had before? Are the wires at significant risk of damage, or is this fine?
Since this might be the wrong place to post this (I'm not sure if it fits under the "systems," category), you are free to move it to its proper location, and I apologize, I tried to use my best judgment.
Moving on to the question, because I did not buy a modular power supply, I have a huge wad of cables, and I have for the most part, successfully hid them away, but this results in a VERY tight fit. There's a slightly noticeable bulge on the thin metal side cover (just to say that I'm not bending 5 feet thick blocks of steel or anything).
Is alright, or if I should just revert back to the clunky wire flooded set-up I had before? Are the wires at significant risk of damage, or is this fine?