- May 27, 2013
- 5
- 0
- 10,510
So I was moving parts from my old case (2nd "build"). Everything worked in the morning, however I decided to dust out my CPU cooler and moved the MOBO with the cooler still attached, I then made a silly mistake of leaving it plugged into the board while dusting it.
My Mother board power light goes green when i give it power but I cannot seem to get the power button case LED to light or get the build to boot.
Did I fry my board when dusting it? I'm fairly certain I hooked up all the front panel buttons correctly (I hoped this was the case but tried several times) and all the parts were working a few hour prior.
Any suggestions would be greatly appreciated.
My Mother board power light goes green when i give it power but I cannot seem to get the power button case LED to light or get the build to boot.
Did I fry my board when dusting it? I'm fairly certain I hooked up all the front panel buttons correctly (I hoped this was the case but tried several times) and all the parts were working a few hour prior.
Any suggestions would be greatly appreciated.
Again I'm not even getting a standby light on the powerswitch
Facebook
Twitter
Instagram