hey guys just made a custom temp backplate for my vapor x (until my 1/4 red plexi comes in) since it was getting the notorious pcb sag. i'm curently just using a 1/8'' plexi with about 1/4 of space across the whole board and its holding it nicely minus the plexi flexing a hair.
my question is is that enough space for the pcb to breathe? i do have a small slot cooler i could incorporate on one end to help vent the pcb.
or would just some simple vent holes here and there be decent enough?
also wish dwood was still making custom backplates since i was going to go that route but it seems he no longer has time to make them.
my question is is that enough space for the pcb to breathe? i do have a small slot cooler i could incorporate on one end to help vent the pcb.
or would just some simple vent holes here and there be decent enough?
also wish dwood was still making custom backplates since i was going to go that route but it seems he no longer has time to make them.