All thinks work on starting my pc all fans work phase led all solid except 2nd led

Sn1992-1361850 · Jul 13, 2013

All thinks work on starting my pc all fans work phase led all solid except 2nd led.....no boot no display only no signal message on monitor.....tried removin graphics card tried clr cmos tried removing cmos battery but didnt wor help plzz

Sys spec
Phenom ii 965
V8 cooler
Msi 785g-e53 mb
850w silent pro m
Cm 690ii advanced
Kingston 1333mhz value ram 2gbx2
Saphire hd 5830 1 gb

I was trying overclocking but seeing temp increase so put to default val but cpu vddc value did not come down from 1.432 it was red in amd overdrive

Help plzzz tried even resetting cpu n cooler checked all cables

Shaun o · Jul 13, 2013

Have you opened your case an reset the bios back to factory default settings.
Power off the system.
Open the side of the case and look inside.
Next to the coin cell battery there will be a set of three pins with a jumper bridging two of the pins. (Bios reset.)

Move the bridge one pin over for about ten seconds and place it back to the position it was in.

Power the system up.

If the system boots, you may have to go into the bios of the board to change some settings like the boot order of your HD and the type of interface mode Sata mode or AHCI.

Sn1992-1361850 · Jul 13, 2013

yes i did ol f dese but it didnt work
What is the main prob in d sys

Sn1992-1361850 · Jul 13, 2013

Need a urgent help

Sn1992-1361850 · Jul 13, 2013

Shaun o :

Yes i did i hv a bttn instead f jumper i prssd it for 1 min but no results

Shaun o · Jul 13, 2013

May of over volted your CPU or damaged the board.
The only way your going to know is to borrow a Cpu off a friend and try there`s in your board.

Or your cpu in there board.
It`s going to be one or the other sorry to say.
What temps was the chip reaching on the overclock ?

Sn1992-1361850 · Jul 13, 2013

First it was 65 plus but for d lst five minutes temps were 48~50 not more dan dat as i reverted to nrml settings but the cpu vddc voltge was 1.432 which was not decreasing n showin dis as min val

Sn1992-1361850 · Jul 13, 2013

Is dere no way to revive it??

Sn1992-1361850 · Jul 13, 2013

There is no one using amd nearby....hv to call a personnel

Sn1992-1361850 · Jul 14, 2013

Cpu minimum pwr led is not lightin rest all phase leds are solid

Search

All thinks work on starting my pc all fans work phase led all solid except 2nd led

Sn1992-1361850

Dignified

Shaun o

Illustrious

Sn1992-1361850

Dignified

Sn1992-1361850

Dignified

Sn1992-1361850

Dignified

Shaun o

Illustrious

Sn1992-1361850

Dignified

Sn1992-1361850

Dignified

Sn1992-1361850

Dignified

Sn1992-1361850

Dignified

TRENDING THREADS

Latest posts

Moderators online

Share this page