Sorry in advance some of these questions i'm sure will be stupid. I have several.
1. The backing plate that sits on the backside of the motherboard, should the plastic be removed that sits on the backing plate or left on?
2. Since mine is the 1150, should I be using the spacing screws from the 1155/1156 or the 2011 for my board?
3. I'm using a Thermaltake Chaser MK-1 case which has a 200mm fan on the top. I'm actually not sure which way it goes if it pushes or pulls. With this in mind the cooler was suggesting to blow air into the case through the top rather pushing it out. Is this what I should be doing with mine or how exactly should I be setting this up?
1. The backing plate that sits on the backside of the motherboard, should the plastic be removed that sits on the backing plate or left on?
2. Since mine is the 1150, should I be using the spacing screws from the 1155/1156 or the 2011 for my board?
3. I'm using a Thermaltake Chaser MK-1 case which has a 200mm fan on the top. I'm actually not sure which way it goes if it pushes or pulls. With this in mind the cooler was suggesting to blow air into the case through the top rather pushing it out. Is this what I should be doing with mine or how exactly should I be setting this up?