I just built a recycled computer from a emachine about 2 or 3 years old and took the parts from its older case which was very small and installed them all in a older hp case which was bigger and allowed me to install a larger GFX card. The only thing different here is the psu which was older than the original one but i had all the adapters for it motherboard fit in fine with all the standoffs and the giant GFX card fit in perfectly.
Only when i went to plug it in to see if it works i got no response. I think the problem was that I didnt install the button pins and stuff correctly which i have always had trouble with recycled machines. I can provide some pictures if that would be helpful!
I dont think this matters, but the PSU in the emachines case had fried while I was using the computer during a power surge. But it seems that that is the only part that is affected?
I could seriously use some help connecting all these pins to the motherboard. I tried them in different places and positions but the most i got were the LED's turning on even when the computer was shutoff. Or so I assumed.
Only when i went to plug it in to see if it works i got no response. I think the problem was that I didnt install the button pins and stuff correctly which i have always had trouble with recycled machines. I can provide some pictures if that would be helpful!
I dont think this matters, but the PSU in the emachines case had fried while I was using the computer during a power surge. But it seems that that is the only part that is affected?
I could seriously use some help connecting all these pins to the motherboard. I tried them in different places and positions but the most i got were the LED's turning on even when the computer was shutoff. Or so I assumed.