Debug LED code 55 and 10 meaning?

Cheeseon

Honorable
Jul 14, 2013
48
0
10,540
I just finished building my PC last night too find that it wouldn't boot. The hard drives, cooler, PSU, Mobo lights, fans, GPUs (SLI), optical drive all work, but when ever I go to boot the computer, the monitor just displays "no signal". The debug LED on the Mobo displays "10" for about five seconds then switches to "55" and stays. I think 55 has something to do with memory but I'm not sure could someone confirm, deny, or specify this?
Also does the 10 code matter and what does it mean ( it goes away ). Any answers are appreciated! Thanks!
 
Solution
E0 S3 Resume is stared (S3 Resume PPI is called by the DXE IPL)
Now for the problem. Open the case and pull the pw connectors from ALL drives; both hd and optical. Disconnect any usb device except the keyboard. Clear cmos or as asus calls it RTC. Now pw ON and see if the board will complete post. You should see an error msg regarding os not found or no bootable disk, etc. Once you are sure the board completes post, then restart and see if you can enter the bios.
E0 S3 Resume is stared (S3 Resume PPI is called by the DXE IPL)
Now for the problem. Open the case and pull the pw connectors from ALL drives; both hd and optical. Disconnect any usb device except the keyboard. Clear cmos or as asus calls it RTC. Now pw ON and see if the board will complete post. You should see an error msg regarding os not found or no bootable disk, etc. Once you are sure the board completes post, then restart and see if you can enter the bios.
 
Solution

Cheeseon

Honorable
Jul 14, 2013
48
0
10,540
Thanks for the advice. I have two questions though. First question is rather stupid, but, what does "stared" mean? Second, how do you reset/clear the CMOS ( my motherboard is an msi z87 gd65 gaming series ) .