ok so i did the stupidest thing ever , i installed a ram and enabled xmp profile and was runing make memtest while i was bored i tried to check the cpu fan my arm was touching the metal part of my case and i could feel slight tingling cuz of electricity and i think i touched one of the capicitors around the fan by mistake cuz suddenly the computer shutdown and it wont turn back up
ok things i tried :
different psu
unhooked everything and started with only the absoulute basics cpu , fan , 1 ram , gpu , keyboard
unhooked gpu and started without it
unhooked ram
built the computer outside the case on a wooden disk
and reset the cmos
oh yea and changed the outlet and the power cable
and all the steps in the perform these if computer wont post-boot-no video
all things point to the fact that i might have fried a capictor that gives power to the cpu cuz the fan wouldnt even do half a rpm when i power on but when i diconnect the cpu power cable the board powers on and turns off ,any ideas??
ok things i tried :
different psu
unhooked everything and started with only the absoulute basics cpu , fan , 1 ram , gpu , keyboard
unhooked gpu and started without it
unhooked ram
built the computer outside the case on a wooden disk
and reset the cmos
oh yea and changed the outlet and the power cable
and all the steps in the perform these if computer wont post-boot-no video
all things point to the fact that i might have fried a capictor that gives power to the cpu cuz the fan wouldnt even do half a rpm when i power on but when i diconnect the cpu power cable the board powers on and turns off ,any ideas??