16 disk RAID with two channels. 3TB Logical Disk E: & 3TB Logical Disk F:. I have repopulated F: with 8 X 2TB drives replacing the older 500 GB drives. I have expanded F: which now has @ 12TB but I can't get the Logical Disk (F to use the extra 9TB.
Here is how the Host Lun List was configured:
Chl Phy No SCSI ID LUN No LD/LV ID Partition ID Partition Size (MB)
0 1 0 LD: 5863D667 0 1668376
0 1 1 LD: 5863D667 1 1668377
1 2 0 LD: 575B15DF 0 1668376
1 2 1 LD: 575B15DF 1 1668377
Now it is the same except for the last entry which is:
1 2 1 LD: 575B15DF 1 11683900
Naturally I want to maintain Fault-Tolerance. Besides figuring out how to expand and use the total capacity on a Logical Drive, do I have to also expand Logical Drive E: to the same capacity as F:?
Here is how the Host Lun List was configured:
Chl Phy No SCSI ID LUN No LD/LV ID Partition ID Partition Size (MB)
0 1 0 LD: 5863D667 0 1668376
0 1 1 LD: 5863D667 1 1668377
1 2 0 LD: 575B15DF 0 1668376
1 2 1 LD: 575B15DF 1 1668377
Now it is the same except for the last entry which is:
1 2 1 LD: 575B15DF 1 11683900
Naturally I want to maintain Fault-Tolerance. Besides figuring out how to expand and use the total capacity on a Logical Drive, do I have to also expand Logical Drive E: to the same capacity as F:?