Sign in with
Sign up | Sign in
Your question
Solved

New motherboard processor and ram installed now no input through the screen.

Last response: in Motherboards
Share
September 2, 2013 9:42:14 PM

Hello, I recently installed a new motherboard, processor, and ram cards. After putting everything together I could get the computer to start but no input was going showing up on my screen. It was getting the connection at least because when it was first plugged in it immediately lit up but then the screen so no signal and shut back off. This has left me stumped and I have no clue what could be wrong, I tried a VGA cable instead and that didn't work and a different screen and that didn't work. Also anything I plug into the USB such as Like a USB light or something like that does not power on, so I also do not know what's going on there. Please help.
Joey
a b V Motherboard
September 2, 2013 9:48:24 PM

Make sure you got the power going to the CPU. It's a little 4 pin square connector with 2 yellow and 2 black wires on it.
m
0
l
a c 207 V Motherboard
September 2, 2013 9:48:35 PM

So, if Im understanding what ya wrote, you took an old Hard Drive with drivers for old hardware on it and tried to boot windows with the drivers for hardware that is no longer there and w/o drivers for the hardware that ya have now ?

No it wont work....wipe HD and install windows again.
m
0
l
Related resources
a b V Motherboard
September 2, 2013 9:49:37 PM

JackNaylorPE said:
So, if Im understanding what ya wrote, you took an old Hard Drive with drivers for old hardware on it and tried to boot windows with the drivers for hardware that is no longer there and w/o drivers for the hardware that ya have now ?

No it wont work....wipe HD and install windows again.


No, he can't get it to post.
m
0
l
a c 207 V Motherboard
September 2, 2013 9:56:24 PM

Ooops ... .didnt read far enuff, my bad

RAM in right slots ?

EPS cable connected (likely an 8 pin, older puters it wud be 4) ?

used Monitor OSD to select correct input ?

PCIE cable to GFX card ?

CPU fan on correct header ?
m
0
l
September 3, 2013 6:13:17 AM

So I currently have my ram in the 2 A channels should I put one in the A channel and one in the B.

m
0
l

Best solution

a c 207 V Motherboard
September 3, 2013 7:17:50 AM

Correct locations for your board are indicated in the manual....A2 and B2 is the most common default location on Asus Dual Channel boards (2nd and 4th from CPU)
Share
!