Hi
I'm doing the annual tear down of my watercooling loop. The only component I want to change is my XSPC acrylic dual bay res for an EK single bay acetal res to save some space. I've been doing some leak testing and the new res won't bleed. My test loop only has Vario D5 pump, XSPC Raystorm cpu block and res attached. I can't seem to get the air out at any speed on my Vario.
I hooked up my old dual bay res and it bled in minutes as usual. Does anyone know any tricks to get this single bay res to bleed quickly? Is it because with so little restriction I can't turn the speed low enough to stop air reentering the loop? If so it won't be a problem once I've got the gpu block and rad hooked up too?
Any help would be appreciated otherwise I've bought a shiny new product I can't use.
Thanks in advance
Mag
I'm doing the annual tear down of my watercooling loop. The only component I want to change is my XSPC acrylic dual bay res for an EK single bay acetal res to save some space. I've been doing some leak testing and the new res won't bleed. My test loop only has Vario D5 pump, XSPC Raystorm cpu block and res attached. I can't seem to get the air out at any speed on my Vario.
I hooked up my old dual bay res and it bled in minutes as usual. Does anyone know any tricks to get this single bay res to bleed quickly? Is it because with so little restriction I can't turn the speed low enough to stop air reentering the loop? If so it won't be a problem once I've got the gpu block and rad hooked up too?
Any help would be appreciated otherwise I've bought a shiny new product I can't use.
Thanks in advance
Mag
Facebook
Twitter
Instagram