Started a computer build last night from microcenter and after everything was put together I didn't get any power. Thinking it was a problem with the motherboard I exchanged it's with another one this morning and now everything runs for about 3 seconds and shuts off (power and reset button on motherboard remains lit). I noticed a few numbers and letters of the Dr debug LED but can't make out anything in the troubleshooting guide. I even try disconnecting all of the cables to the motherboard just leaving the main 24 pin cable and the eight pin CPU cable and the same thing happens. maybe there is a problem with the processor from the initial install with the first motherboard board?
I should also state that I am using my Seagate Barracuda hard drive, video card and RAM from my previous computer and plan on cloning my new hard drive (sshd) as boot but even with everything disconnected I dont see that is the problem.
Build:
ASRock 970 Extreme 4
AMD FX-8350
Crucial Ballistic Sport RAM 2x8GB
EVGA Geforce GTX 660 SC
Seagate SSHD 1TB
Seagate Barracuda HDD 3TB
Antec 620 Liquid Cooler
Corsair CX750M PSU
I should also state that I am using my Seagate Barracuda hard drive, video card and RAM from my previous computer and plan on cloning my new hard drive (sshd) as boot but even with everything disconnected I dont see that is the problem.
Build:
ASRock 970 Extreme 4
AMD FX-8350
Crucial Ballistic Sport RAM 2x8GB
EVGA Geforce GTX 660 SC
Seagate SSHD 1TB
Seagate Barracuda HDD 3TB
Antec 620 Liquid Cooler
Corsair CX750M PSU
Facebook
Twitter
Instagram