Sign in with
Sign up | Sign in
Your question
Solved

CM 690 III VS Thermaltake Chaser A31

Last response: in Components
Share
September 27, 2013 4:03:04 AM

Need Suggestion For Buying Between These Casings

CM 690 III VS Thermaltake Chaser A31

http://www.thermaltake.com/products-model_Specification...

http://www.coolermaster.com/product/Detail/case/mid-tow...

which will be better in perfomance,cooling,looking any other thing do you know about cases need suggestions from Experties......

My Specs
Core i5 4th Gen 4670K
Asus Maximus Formula
16 GB Corsair Dominator 1600 Mhz
1 TB HDD
128 GB SSD Neutron
GS 800/TX 850
Thermaltake Frio Advanced

Regards
Moosa Aslam

September 27, 2013 5:05:21 AM

Both of them are good in cooling but it looks like the thermaltake one has more case fan. The thermaltake one definitely looks cooler(awesome). I would definitely go for the Chaser.
September 27, 2013 7:15:10 AM

ANY OTHER ?????
Related resources

Best solution

September 27, 2013 8:24:31 AM
Share

The coolermaster.
September 27, 2013 8:44:57 AM

I like them both. But I would probably opt for the Cooler Master simply because it appears to have more room behind the MB tray for cable management. Even with the slight side panel bulge, the Chaser A31 looks tight back there. But that's just me.
November 29, 2013 5:03:28 AM

I just had the same choice last week, went with the Cooler Master. Then both the shop and I were surprised to find a water cooler bundled into the package (it was in an unmarked box within the case). No regrets here. I think there are actually several model numbers of this case with different components. This was an early one, as it lacked the rubber grommets around the wiring holes, which CM says it will ship - however, I found that the case was finished well enough that the rubber wasn't really needed. Note that if you really only need two drives, the 690 III will let you remove the middle set of drive bays, improving airflow - I don't think the Chaser will allow for that, which was one reason I decided on the CM. Have fun building!
November 29, 2013 10:07:15 PM

rockyd2 said:
I just had the same choice last week, went with the Cooler Master. Then both the shop and I were surprised to find a water cooler bundled into the package (it was in an unmarked box within the case). No regrets here. I think there are actually several model numbers of this case with different components. This was an early one, as it lacked the rubber grommets around the wiring holes, which CM says it will ship - however, I found that the case was finished well enough that the rubber wasn't really needed. Note that if you really only need two drives, the 690 III will let you remove the middle set of drive bays, improving airflow - I don't think the Chaser will allow for that, which was one reason I decided on the CM. Have fun building!


take a look here
http://www.tomshardware.com/forum/id-1879112/haswell-ri...
!