Hi Again,
I am new on here and have learnt a lot so far. I have my XSPC RS750 kit installed in a very bad place so I'm going to move it with the rad out the back (I have a Koolance quick release mount on its way).
Please let me know what you guys think about this loop, I have tried my best to 'paint' it on. Note on the right hand side I have two different connector configs possible.
Key:
90 = 90 degree connector
45R = 45 degree rotatable connector
EXTND = 41-69mm extender fitting
Yellow lines = tubing
I would love to add my GPU (Gigabyte GTX 770 oc 4GB Windforce - GV-N770OC-4GD) on to the loop but I can't find a block for it anywhere
All comments are welcome, especially those that will improve my loop. Also, if anyone knows where I can find a block for my GPU (if there even is one) I will give you a cookie!
I am new on here and have learnt a lot so far. I have my XSPC RS750 kit installed in a very bad place so I'm going to move it with the rad out the back (I have a Koolance quick release mount on its way).
Please let me know what you guys think about this loop, I have tried my best to 'paint' it on. Note on the right hand side I have two different connector configs possible.
Key:
90 = 90 degree connector
45R = 45 degree rotatable connector
EXTND = 41-69mm extender fitting
Yellow lines = tubing
I would love to add my GPU (Gigabyte GTX 770 oc 4GB Windforce - GV-N770OC-4GD) on to the loop but I can't find a block for it anywhere
All comments are welcome, especially those that will improve my loop. Also, if anyone knows where I can find a block for my GPU (if there even is one) I will give you a cookie!
Facebook
Twitter
Instagram