Sign in with
Sign up | Sign in
Your question
Solved

Quick question about Crossfire Bridge

Tags:
  • Graphics
Last response: in Graphics & Displays
Share
September 30, 2013 2:02:11 PM

Does it matter which Crossfire Bridge i use? I accidentally got some loctite glue on one of the bridges (the one furthest to the end of the case). So i was just wondering if it matters which crossfire port i plug into. I was going to try to use Acetone to get the glue off of the one connector but i feel that's risky...unless someone else has done it.

More about : quick question crossfire bridge

Best solution

September 30, 2013 2:27:32 PM

it doesn't matter which bridge you put your connector on, it will only effect you if you want to go 3 or 4 way crossfire. I would still recommend trying to clean the bridge on your card where you got the glue. An old school method is using a eraser on the tip of a pencil, you can also use some 99% alcohol with a lint free rag.
Share
September 30, 2013 2:30:00 PM

I would also recommend just holding the rag with the alcohol and not rubbing it on the connector. Just let the glue come off with just a little bit of time from holding the rag onto it
m
0
l
!