Any suggestions? i have a nzxt switch 810 case, and I would like to place a fan on the window due to my GPU cards heat exhaustion. The ACX cooler takes air from outside and then pushes the air out as heat into my case. I was thinking a 140mm or 120mm. What would be the most efficient way to cut this window?
Couldn't find the right category, but this is about cutting through the window of my side panel
- Thread starter Garrett__
- Start date
Very carefully and with very precise measurements.
Draw a mockup using tracing paper and then mark the drill holes with permanent marker. Use a drill matched to the diameter of the screws that you are going to use and carefully drill the holes while the panel is mounted in a vice or bench grip.
Cutting the window is going to be a bit more difficult. A Dremel tool will get the job done well enough if you can get your hands on one.
Draw a mockup using tracing paper and then mark the drill holes with permanent marker. Use a drill matched to the diameter of the screws that you are going to use and carefully drill the holes while the panel is mounted in a vice or bench grip.
Cutting the window is going to be a bit more difficult. A Dremel tool will get the job done well enough if you can get your hands on one.
TRENDING THREADS
-
-
-
Question r9 390 a good budget option since rx 580s are overpriced?
- Started by jordanbuilds1
- Replies: 3
-
News Windows 11 will reportedly display a watermark if your PC does not support AI requirements- Started by Admin
- Replies: 6
Facebook
Twitter
Instagram