I recently ordered 5 units of Deepcool Iceblade 120mils for my case. I assumed that it will come with the necessary adapters and screws, but unfortunately, it didn't. What I got in the package is just the fan and a 4-pin Female to 2x 4-pin Male Y-Splitter.
Then I realized later on that the fans I ordered are PWM or "heatsink" fans. Now my problem is how will I be able to use it as a standard case fan.
Im thinking of using a standard 4-pin Male Molex to 3-pin Male Fan connector, and just chip the side of the plastic cap of the 3-pin fan connector so the 4-pin female connector of the fan will fit. Is that going to work?
Worst case, I'm considering of getting one of these ( http://www.deepcool-us.com/Product/Fun_Hub/ ) since these have 4-pin male connectors. But I'm not so sure if it's a good idea to have 4 fans connected to a single motherboard 4-pin fan header.
Any other suggestions?
Then I realized later on that the fans I ordered are PWM or "heatsink" fans. Now my problem is how will I be able to use it as a standard case fan.
Im thinking of using a standard 4-pin Male Molex to 3-pin Male Fan connector, and just chip the side of the plastic cap of the 3-pin fan connector so the 4-pin female connector of the fan will fit. Is that going to work?
Worst case, I'm considering of getting one of these ( http://www.deepcool-us.com/Product/Fun_Hub/ ) since these have 4-pin male connectors. But I'm not so sure if it's a good idea to have 4 fans connected to a single motherboard 4-pin fan header.
Any other suggestions?