Trouble seating 24 pin connector into the motherboard

tradeagreement

Honorable
Oct 7, 2013
8
0
10,510
Hey all, I'm having a lot of trouble seating the 24 pin connector into the motherboard for some reason. I applied a lot of force to the extent that the motherboard began to flex, but the 24 pin connector was still not securely latched on.

I took the motherboard out of the case to connect it, but the same thing happened. I'm pretty sure that there's nothing obstructing the connectors since they were both new out of the box.

I'm using ASRock B84M-ITX with a Corsair CX750M.

This is what it looks like:
http://i.imgur.com/dM7KI.jpg
 
Solution
It is possible that an extension would help, at least it could allow you to plug it into the board without excessive flexing that can damage your board.

Is the bottom of the 24 port adapter flush with the motherboard, almost looks as if it is raised off the board a bit, although that could just be an illusion from the picture.

I would also look at each pin and slot to see if the metal portion has any defects, I've seen a few of those over the years that needed a little modding to fit together.

tradeagreement

Honorable
Oct 7, 2013
8
0
10,510


Everything looks fine to me. I suspect this might be a manufacturer's defect or something...do you think getting an extension cable would be a good idea?



I've tried this already, and the result was more or less the same.
 

RealBeast

Titan
Moderator
It is possible that an extension would help, at least it could allow you to plug it into the board without excessive flexing that can damage your board.

Is the bottom of the 24 port adapter flush with the motherboard, almost looks as if it is raised off the board a bit, although that could just be an illusion from the picture.

I would also look at each pin and slot to see if the metal portion has any defects, I've seen a few of those over the years that needed a little modding to fit together.
 
Solution