my computer is goes strait to the asrock uefi startup utility menu

emmilash

Honorable
Oct 29, 2013
3
0
10,510
I have the same thing every time i start my computer is goes strait to the asrock uefi startup utility menu, but I have not been playing with the computer settings. last night i was on the Internet just hanging out and decided to turn the monitor off instead of the computer. In the morning i turned the monitor back on and the screen was frozen so I manually restarted the computer and when it came back up it whent strait to the asrock uefi startup utility menu and now it is stuck there, and I can get windows to start. anyone know how to do that?
 
Solution


The Fn keys can be used to issue commands to the UEFI (BIOS). Try pressing F1 and see if it brings up a list of Fn associated commands. Look for "Quit Without Saving Changes", and press...


The Fn keys can be used to issue commands to the UEFI (BIOS). Try pressing F1 and see if it brings up a list of Fn associated commands. Look for "Quit Without Saving Changes", and press that Fn key. That should get you out of the UEFI and force a re-boot.

Good luck!

Yogi

 
Solution

emmilash

Honorable
Oct 29, 2013
3
0
10,510
ok thanks for the suggestions but nether of the are working every time i try to exit the asrock uefi setup menu i ether restart the computer and it goes right back to the menu or it "loads" the menu again. I also tried to re-install windows but it says it can't find the drivers. Then I used the disk that came with the computers that says driver, utities and user manual but that got into a endless loop of restarting the computer, I load the disk and it say to restart the computer (i think it was supposed to happen automaticaly but it does not so i tryed and loop). thanks for responding
 

emmilash

Honorable
Oct 29, 2013
3
0
10,510
I got it working there is a reset button right next to the power button and I must have hit that this morning, but not the other 100 times i tried restarting my computer today. all i had to do was hit the reset again and reseat the copm and now it is back.