Antec three hundred MOBO installing question PLEASE HELP

Toggle sidebar Toggle sidebar
L

LarryFin

Honorable
Oct 21, 2013
25
0
10,530
I have bought antec three hundredfpr the case for my build and with motherboard i went with Asus m5a97 le r2.0
So i have installed CPU and RAM. I watched at my cases and motherboards manuals to see what scews to use, but my motherboard didnt come with any screws and its manual doesnt say anything about screws and y case manual just says "use phillips-head screws" but my case comes with two sorts of phillips screws. Big ones with little notches on the flip side of the screw and smaller ones with flatflip side. If you now anything about his please answer Im trying to finish the build today.
Thank you so much for your answer ~ Larry
 
Solution
V
Use anything that threads easily into the standoffs! I usually wind up using the hex-head screws that will accept either a Phillips drivers or a small nutdriver...you see them a lot holding down PCI expansion cards at the back of the case, but they work well to hold down a MB too.
Sort by date Sort by votes
V

videobear

Honorable
Feb 27, 2012
103
0
10,710
Use anything that threads easily into the standoffs! I usually wind up using the hex-head screws that will accept either a Phillips drivers or a small nutdriver...you see them a lot holding down PCI expansion cards at the back of the case, but they work well to hold down a MB too.
 
Upvote 0 Downvote
Solution
You must log in or register to reply here.

TRENDING THREADS

Latest posts

Moderators online

Share this page

COMPANY
RESOURCES
FOLLOW
Top Bottom