I get a "No signal" message when I turn on my aerocool cyborg x pgs r computer

WickedPC

Honorable
Nov 23, 2013
5
0
10,510
I have an aerocool cyborg x pgs r computer that has been in storage (in original packaging) for the last 6 months. After unpacking everything, reconnecting all cables and powering up I have received a "No Signal" message on the monitor. I have checked for any dust, etc and have quadruple checked each cable. I'm out of ideas. Any suggestions would be greatly appreciated.

Thanking you in advance
 

WickedPC

Honorable
Nov 23, 2013
5
0
10,510


 

WickedPC

Honorable
Nov 23, 2013
5
0
10,510
Hi Jinksy,

Thankyou for responding to my enquiry.

I am not sure if the machine has on board graphics or an additional graphics card. I did not build this computer. It belongs to my nephew. Usually I can fumble my way through troubleshooting but this computer is different to any others that I have used. It has a multitude of cables and I'm not sure if there are any missing. I have tried to search online for a user manual or initial setup guide to no avail. I used to consider myself computer savy until I came across the cyborg.

Any help would be greatly appreciated.

Thanking you in advance