- Dec 10, 2013
- 2
- 0
- 10,510
Hi there,
I'm trying to boot Unibeast onto a Hackintosh with an ASUS Rampage IV Extreme MOBO.
So I've got the Unibeast screen booted from the USB where you can select what to install from.
If I try to boot directly from the USB by pressing enter, the Apple logo appears (no status bar, just the Apple) and it just stays there for 10+ minutes until I reset it.
I have tried loads of different boot commands, including GraphicsEnabler=No/Yes (entered separately), PCIRootUID=0/1 etc - none work.
When I boot in Verbose (-v or by selecting Boot Verbose from the drop down) then it runs through the boot process, then within a minute the monitor turns off. I can't see if it's stopping the install and shutting the monitor off, or if it carries on installing without the display.
Full spec of the machine is:
-: Intel Core i7 4930K 3.4GHz (Ivy Bridge-E)
-: G.Skill TridentX 32GB (4x8GB) DDR3 RAM
-: ASUS Rampage IV Extreme MOBO
-: ASUS Radeon 7870 Graphics Card
-: SanDisk 128GB SSD
-: WD 4TB HDD (X2, currently disconnected)
-: Corsair H100i Water Cooling System
-: Cooler Master Case
-: Novatech Modular Power Supply
Connected to an LG HD Gaming Monitor, currently via DVI (although I will hopefully be using HDMI).
You can see a video of what's happening here: https://www.youtube.com/watch?v=94fkApNSPJU
The process stops on:
Starting Darwin x86_64
Boot Args: boot-uuid=FAAA3CFB-04D6-3080-81D5-EC9909B0 rd=*uuid -v
Any help would be greatly appreciated!
I'm trying to boot Unibeast onto a Hackintosh with an ASUS Rampage IV Extreme MOBO.
So I've got the Unibeast screen booted from the USB where you can select what to install from.
If I try to boot directly from the USB by pressing enter, the Apple logo appears (no status bar, just the Apple) and it just stays there for 10+ minutes until I reset it.
I have tried loads of different boot commands, including GraphicsEnabler=No/Yes (entered separately), PCIRootUID=0/1 etc - none work.
When I boot in Verbose (-v or by selecting Boot Verbose from the drop down) then it runs through the boot process, then within a minute the monitor turns off. I can't see if it's stopping the install and shutting the monitor off, or if it carries on installing without the display.
Full spec of the machine is:
-: Intel Core i7 4930K 3.4GHz (Ivy Bridge-E)
-: G.Skill TridentX 32GB (4x8GB) DDR3 RAM
-: ASUS Rampage IV Extreme MOBO
-: ASUS Radeon 7870 Graphics Card
-: SanDisk 128GB SSD
-: WD 4TB HDD (X2, currently disconnected)
-: Corsair H100i Water Cooling System
-: Cooler Master Case
-: Novatech Modular Power Supply
Connected to an LG HD Gaming Monitor, currently via DVI (although I will hopefully be using HDMI).
You can see a video of what's happening here: https://www.youtube.com/watch?v=94fkApNSPJU
The process stops on:
Starting Darwin x86_64
Boot Args: boot-uuid=FAAA3CFB-04D6-3080-81D5-EC9909B0 rd=*uuid -v
Any help would be greatly appreciated!
Facebook
Twitter
Instagram