New DIY desktop wont start.

Toggle sidebar Toggle sidebar
D

dota2er

Honorable
Nov 15, 2013
147
0
10,680
I just finished building my desktop. But I cannot boot up. The standby power LED is on, but after I press start bottom there are no respond but a momentary sound. Can you give me any advise?
Here is about my build, see if there is any compatible matter. Thanks:D
http://pcpartpicker.com/p/2ghnF
 
Solution
rvilkman
Well everything is compatible, so that is not the problem. Since it's an asus board, the first thing i would get is that if you used the combination riser for the front panel connectors, that all of those including the riser are properly connected to the motherboard. I had a similar problem with my machine when i first put it together.

Then check that all power cables are connected to the motherboard and graphics cards properly.

Sort by date Sort by votes
D

dota2er

Honorable
Nov 15, 2013
147
0
10,680


Thanks for answering. I found the problem. It is a little bit stupid. I pluged the pci-e side into psu and plug the power side in to graphic card. ::ouch:
 
Upvote 0 Downvote
rvilkman

rvilkman

Distinguished
Jun 12, 2009
2,307
0
20,960
Well everything is compatible, so that is not the problem. Since it's an asus board, the first thing i would get is that if you used the combination riser for the front panel connectors, that all of those including the riser are properly connected to the motherboard. I had a similar problem with my machine when i first put it together.

Then check that all power cables are connected to the motherboard and graphics cards properly.

 
Upvote 0 Downvote
Solution
You must log in or register to reply here.

TRENDING THREADS

Latest posts

Moderators online

Share this page

COMPANY
RESOURCES
FOLLOW
Top Bottom