- Dec 12, 2013
- 1
- 0
- 10,510
Hi,
I'm a newbie and this might seem like dumb question, but I could not find any good answers by looking at this board or endless youtube videos.
I'm installing a mini-itx board (Foxconn D70S-P) in a Metal ATX Case. I/O Panel and screw locations match fine, I'm just worried that part of the underside of the board is touching bare metal. Wouldn't this short the board? Why not?
Should I put in some spacers or some kind of non conducive material between board and case? My case is an Apex PC-375.
I'm a newbie and this might seem like dumb question, but I could not find any good answers by looking at this board or endless youtube videos.
I'm installing a mini-itx board (Foxconn D70S-P) in a Metal ATX Case. I/O Panel and screw locations match fine, I'm just worried that part of the underside of the board is touching bare metal. Wouldn't this short the board? Why not?
Should I put in some spacers or some kind of non conducive material between board and case? My case is an Apex PC-375.
Facebook
Twitter
Instagram