Lights, and Fans work, no beep or signal to monitor

skatenate11

Honorable
Nov 14, 2013
23
0
10,510
Hi. I know this question is asked a a lot but I am not getting help from them. I am not getting signal from my graphic card to my tv, I don't know why because my graphic card fans spin,my CPU fans spin, and my case fans spin. I put my mobo directly in case I didn't try breadboarding and i connected all the headers and proceeded, only my fans and hdd worked. No beep or signal. Then I took it out and breadboard that didn't work either.

Specs

CPU: AMD FX-6300 3.5GHz(4.1 GHz Turbo) socket AMD3+ six core

CPU COOLER: stock

MOBO: Gigabyte GA-970A-UD3P

RAM: GSKILL RIPJAWS X series
F3-12800-CL8D-8gbxm

VIDEO CARD: EVGA
04G-P4-2768-KR

POWER SUPPLY: CORSAIR CX750M
750watt

HARD DRIVE: SEAGATE BARRACUDA
2TB

OS: WINDOWS 7 64BIT

CASE: THERMALTAKE COMMANDER.
White

OTHER: CD DRIVE

STEPS I TOOK TO RESOLVEY SELF
1.check CPU and main motherboard power
2.Reseated my graphics card
3.Try to switch ram around and I tryed only one
4.took my motherboard
5. Breadboarding



 
Solution
To whom? The Gigabyte? Just tell them everything you told us. Tell them you can not make it work. Make sure you talk about motherboard and not your graphic card, otherwise, they will send you to graphics manufacturer. Just tell them what you getting. Most likely they will replace it. Tell them that you in school and need computer ASAP, and to pre-send motherboard now without waiting for return. They sure have other tips to test it.

Astralv

Distinguished
I dont know what graphics that is, but check your power to the card. Are you connecting via HDMI? You need to use VGA or DVI port to troubleshoot. Also I have the same memory you have and I have severe problems right now with XMP profile. I have POST loop.
 

Astralv

Distinguished
Yeah, I was looking at my voltage selector last night- not a word in manual, so I left it the way it was...

I am talking about red led light on the motherboard- it would have words, saying what light is for. Also there may be red or green lights on the graphic cards. Some cards have 1 connector, others- 2. I would expect 2 6 pin connectors for your card. It may be 6 and 8 but I doubt it. Make sure you connecting right 6 pins, there is difference. 6+2 connectors are usually for motherboard.
 

Astralv

Distinguished
If you did not change anything in BIOS, CMOS is not likely would help. If you still not getting signal with regular monitor, you may start calling Gigabyte. Also you never told me if you have post led lights turning red and then go off during the post and if you installed motherboard speaker.
 

Astralv

Distinguished
I am trying to figure out if it is your graphics or motherboard. Did you install speaker? Did you connect 24 and 8 pins power connectors to the motherboard? Is there any led lights on the board? Were you using your monitor with the same port (VGA) as you connecting now? (some monitors do not respond to signal type change and need manual change from DVI to VGA). What is the graphic card doing? Any lights, fans working?
 

skatenate11

Honorable
Nov 14, 2013
23
0
10,510
I think my monitor get signal because it stop switching from hdmi to analog but thin my monitor goes into stand by.I don't see any light in my motherboard come on or off. I pluge speaker in right but get no beep