I fixed my issue.
This is what I did:
Instead of using the DVI, I used a VGA.
Since my video card doesn't support VGA I also had to use a converter.
After plugging in the VGA I right away got a signal.
But It wasn't over yet... I had another problem, my monitor resolution wasn't there. So I went ahead and downloaded the Beta drivers (latest ones). And while installation I had a box pop out that asked me If I would like to install "Display Drivers" I Pressed "Install"... And that gave me my right monitor resolution back.
Problems didn't end yet tho.
My last problem was: If I used 60 Hertz then the screen looked as if the monitor screen was wet... I couldn't read anything.
When I placed 75 Hertz everything look crystal clear BUT I had unfixable borders around the screen.
Finally, I just went into "Create Custom Resolution" and set these settings:
1600 x 1050
This fixed everything
Is there anything I should know? Does anyone think they know why my DVI does not work... Thank You!