Ok Im having trouble getting my monitor to connect to my vga it says no signal.. I have an amd a8 5600k running dual graphics with a radeon 6670. I changed my bios to boot up with pci i plug the vga to the gpu and back of monitor and i get no signal. I remove gpu and use rgb to motherboard and it works fine. however if i use vga on motherboard it wont boot up. the drivers are all up to date. the vga cable is fairly new. The graphics card fan spins and computer recognizes it. I did a fresh install of windows 64 bit so i wiped hard drive and reinstalled all the drivers. before this it booted up with vga connected to gpu and all teh settings were set to run in dual graphics mode. Any idea what is wrong?
-
Multi-million dollar Cheyenne supercomputer auction ends with $480,085 bid — buyer walked away with 8,064 Intel Xeon Broadwell CPUs, 313TB DDR4-2400 ECC RAM, and some water leaks
Help with VGA cable!!!
- Thread starter Jhop23
- Start date
TRENDING THREADS
-
-
News Firefox user loses 7,470 opened tabs saved over two years after they can’t restore browsing session- Started by Admin
- Replies: 58
-
News Apple debuts M4 processor in new iPad Pros with 38 TOPS on neural engine
- Started by Admin
- Replies: 76
-
Question Can't run .exe files to reinstall or restore Windows 10, can run SFC from boot or in system
- Started by David_652
- Replies: 6
Latest posts
-
-
Question All Peripherals Momentarily Disconnect Due to BTHUSB Event ID 18 Issue.
- Latest: CodeConnoisseur
Facebook
Twitter
Instagram