No display with new ram.

Toggle sidebar Toggle sidebar
thatmoney

thatmoney

Honorable
Dec 26, 2013
184
0
10,710
Today I bought 16gb x 2 sticks of pny memory today. I installed it and started up my computer and there is no display on my monitor. I thought my memory was dead but, when I put only one stick of memory in my computers boots up fine. I am very confused and have no idea why this is happening, my motherboard is a ms-7778.
 
Solution
Astralv
Do you mean- you put 1st stick of memory and it boots, but it would not boot with 2 sticks and it would not boot with 2nd single stick? Or do you mean- each (both) stick/s works one at a time but not together? What memory? What do you see in BIOS? Try to enable XMP profile. Check the placement- it should be A2B2, not A1B1 (check your manual).
Sort by date Sort by votes
Astralv

Astralv

Distinguished
May 6, 2013
1,916
9
20,015
Do you mean- you put 1st stick of memory and it boots, but it would not boot with 2 sticks and it would not boot with 2nd single stick? Or do you mean- each (both) stick/s works one at a time but not together? What memory? What do you see in BIOS? Try to enable XMP profile. Check the placement- it should be A2B2, not A1B1 (check your manual).
 
Upvote 0 Downvote
Solution
thatmoney

thatmoney

Honorable
Dec 26, 2013
184
0
10,710
Hmmm, after undoing a2/b2 placement because it didn't work and leaving one stick of memory in I was greeted with every error possible and a bsod. Will replace it with other memory stick to configure xmp profile and try to figure it out. And also to answer your earlier question, it only boots up with one stick in it at a time.
 
Upvote 0 Downvote
You must log in or register to reply here.

TRENDING THREADS

Latest posts

Moderators online

Share this page

COMPANY
RESOURCES
FOLLOW
Top Bottom