Design an IPv4 addressing scheme and complete the Addressing Table based on the following requirements. Use the table above to help you organize your work.
a. Subnet the 192.168.1.0/24 network to provide 30 host addresses per subnet while wasting the fewest addresses.
b. Assign the fourth subnet to the LAB 124-C LAN.
c. Assign the last network host address (the highest) in this subnet to the G0/0 interface on CS Department.
d. Starting with the fifth subnet, subnet the network again so that the new subnets will provide 14 host addresses per subnet while wasting the fewest addresses.
e. Assign the second of these new 14-host subnets to the LAB 214-A LAN.
f. Assign the last network host address (the highest) in the LAB 214-A LAN subnet to the G0/1 interface of the CS Department router.
g. Assign the second to the last address (the second highest) in this subnet to the VLAN 1 interface of the LAB 214-A Switch.
h. Configure addresses on the hosts using any of the remaining addresses in their respective subnets.
I do have the topology! on the right side of the network there are 2 pc connected to a switch and the switch to the Router labeled CS department. The other side of the network is a pc and a file server connected to a switch and that switch also connected to the same router CS department .
i need the ip address of three pcs with ip address and subnet mask
tftp server with ip address and subnet mask
a. Subnet the 192.168.1.0/24 network to provide 30 host addresses per subnet while wasting the fewest addresses.
b. Assign the fourth subnet to the LAB 124-C LAN.
c. Assign the last network host address (the highest) in this subnet to the G0/0 interface on CS Department.
d. Starting with the fifth subnet, subnet the network again so that the new subnets will provide 14 host addresses per subnet while wasting the fewest addresses.
e. Assign the second of these new 14-host subnets to the LAB 214-A LAN.
f. Assign the last network host address (the highest) in the LAB 214-A LAN subnet to the G0/1 interface of the CS Department router.
g. Assign the second to the last address (the second highest) in this subnet to the VLAN 1 interface of the LAB 214-A Switch.
h. Configure addresses on the hosts using any of the remaining addresses in their respective subnets.
I do have the topology! on the right side of the network there are 2 pc connected to a switch and the switch to the Router labeled CS department. The other side of the network is a pc and a file server connected to a switch and that switch also connected to the same router CS department .
i need the ip address of three pcs with ip address and subnet mask
tftp server with ip address and subnet mask
Facebook
Twitter
Instagram