Sign in with
Sign up | Sign in
Your question
Solved

Overclocking failed please enter setup to reconfigure your system

Last response: in Systems
Share
December 30, 2013 9:04:23 AM

When i start up my computer, it won't start and gives me this message: "overclocking failed please enter setup to re-configure your system". I've gotten these messages in the past a few times. I've just booted the PC and it has worked, this time it doesn't.

I havn't overclocked or touched the BIOS settings at all after installing windows ~6months ago.

I've reset BIOS settings, cleared CMOS with jumpers, took out the battery for a few mins, tried different RAM voltages. Nothing has worked thus far. It just gives me the same error message over and over again.

Here's my PC specs:

SEAGATE BARRACUDA 1TB 3.5" SATA3 7.2K 64MB
Gigabyte GTX770 2GB PCI-E OC
ASUS DRW-24B5ST 24X DVDRW
KINGSTON V300 120GB SSD 450/450Mb/s
KINGSTON HYPERX 8GB 1600MHZ DDR3 (2x4GB)
Intel i5-4670K 3.40GHz 6M
ASUS Z87-K LGA1150 Intel Z87 4xDDR3
ANTEC KUHLER H2O 620 1366/1156/775/AM3/2
CORSAIR Builder Series CX 600 Watt 80+

Thanks in advance!

Best solution

a b K Overclocking
December 30, 2013 9:10:36 AM

I would say update your bios , I cant see what the bios revisions are since the site seems screwed up
Share
December 30, 2013 9:12:46 AM

I'm no expert at overclocking, but I recommend you reset your Bios (defaults), configure everything but the overclocking again, and then if you still want to overclock, overclock without changing the cpu voltage. If it goes well from there, then try some minor voltage tweaks.
m
0
l
Related resources
a b K Overclocking
December 30, 2013 9:42:22 AM

TechnoD said:
I'm no expert at overclocking, but I recommend you reset your Bios (defaults), configure everything but the overclocking again, and then if you still want to overclock, overclock without changing the cpu voltage. If it goes well from there, then try some minor voltage tweaks.


he said he has not overclocked and has already reset the bios.
m
0
l
June 3, 2014 5:18:34 AM

Hey dude, did you get a solution for this issue?
I have pretty much the same configuration, and got the same message yesterday.
Thanks
m
0
l
!