Hey guys.
I'm going to make this quick and short.
I have an NZXT Lexa S case and when i first built my PC the fans were run through molex connectors making them go 100 % all the time.
After alot of loud noise i wanted to change that, now i saw this video:
http://www.youtube.com/watch?v=11lM0JWst5I
And i realized that i should have plugged my fans into those 1 and 2 sockets.
So i did that and after that,the fans were not even spinning ?!
I tried using the knobs on the front panel but nothing.
So i saw an empty molex connector which was labeled FAN CONTROLLER and i plugged it in, and now the fans are working again, but with the same problem.
No matter how much I turn the knobs the fans are still running at 100% and if you look at the video above there IS a difference.
So can anyone help me figure out what the problem is ?
Also the molex have been disconnected incase your wondering that is the problem.
Thanks.
I'm going to make this quick and short.
I have an NZXT Lexa S case and when i first built my PC the fans were run through molex connectors making them go 100 % all the time.
After alot of loud noise i wanted to change that, now i saw this video:
http://www.youtube.com/watch?v=11lM0JWst5I
And i realized that i should have plugged my fans into those 1 and 2 sockets.
So i did that and after that,the fans were not even spinning ?!
I tried using the knobs on the front panel but nothing.
So i saw an empty molex connector which was labeled FAN CONTROLLER and i plugged it in, and now the fans are working again, but with the same problem.
No matter how much I turn the knobs the fans are still running at 100% and if you look at the video above there IS a difference.
So can anyone help me figure out what the problem is ?
Also the molex have been disconnected incase your wondering that is the problem.
Thanks.
Facebook
Twitter
Instagram