I have a Western Digital WD20EADS-32S2B0 2TB hard drive rescued from a My Book External Hard Drive when the USB connector fell off. Can I either replace the board with the USB connector or is there a way for my inateck docking station to see the WD drive. None of the jumpers are set at the moment.
Instructions on back of drive say pins 1&2 enables SSC (Speed Spectrum Clocking
3&4 enables PUIS (Power up in Standby)
5&6 enables 1.5GB PHY
Instructions on back of drive say pins 1&2 enables SSC (Speed Spectrum Clocking
3&4 enables PUIS (Power up in Standby)
5&6 enables 1.5GB PHY
Facebook
Twitter
Instagram