I just bought a new i7 4770k and an Asus z87 -a and 32 GB of Patriot 2133 mhz RAM to upgrade my current build.
Current Build:
New Build:
I installed my motherboard in my case, added RAM and CPU then connected everything with my PSU. Started. POST had no problems.
Next I pressed F2 to enter UEFI and clicked on advanced settings... Suddenly a freeze occured when I scrolled down a bit then I turned off the computer after waiting 2-3 minutes.
Then I tried turning it on to notice:
So I cleared CMOS by following the steps in the manual but it's still not working. And yes I checked different RAM, cpu for bent pins. PSU is working on my other build. It doesn't look like a PSU/CPU/RAM problem.
Current Build:
Corsair TX850
Gigabyte 870a-ud3
i7 860
Kingston 2x4 GB DDR3 RAM 1600 mhz
Samsung 830 SSD
New Build:
Corsair TX850
Asus z87 -a
i7 4770k
4x8 GB Patriot 2133 mhz
Samsung 830 SSD
I installed my motherboard in my case, added RAM and CPU then connected everything with my PSU. Started. POST had no problems.
Next I pressed F2 to enter UEFI and clicked on advanced settings... Suddenly a freeze occured when I scrolled down a bit then I turned off the computer after waiting 2-3 minutes.
Then I tried turning it on to notice:
Fans are working
DRAM LED flashing red
CPU LED is flashing red
So I cleared CMOS by following the steps in the manual but it's still not working. And yes I checked different RAM, cpu for bent pins. PSU is working on my other build. It doesn't look like a PSU/CPU/RAM problem.