Designing a case...dimension needed

Toggle sidebar Toggle sidebar
H

HaNd_SoLo

Honorable
Jan 28, 2014
7
0
10,510
What's the spec for distance between the motherboard mounting surface and the opposite edge of an expansion card? I'm trying to make the case as flat as possible.
 
Solution
D
If it is the same as the SSI specification, then here is the quote from their spec:
"The heights provided are from the t
op of the baseboard. A baseboard thic
kness of 1.57mm [0.062”] nominal is
highly recommended to ensure baseboard features mate
properly to corresponding chassis features. A
secondary-side clearance of 3.00mm [0.118”] is
available for leads and backside components. "
Sort by date Sort by votes
D

DeauteratedDog

Distinguished
Dec 11, 2013
713
89
19,540
If it is the same as the SSI specification, then here is the quote from their spec:
"The heights provided are from the t
op of the baseboard. A baseboard thic
kness of 1.57mm [0.062”] nominal is
highly recommended to ensure baseboard features mate
properly to corresponding chassis features. A
secondary-side clearance of 3.00mm [0.118”] is
available for leads and backside components. "
 
Upvote 0 Downvote
Solution
You must log in or register to reply here.

TRENDING THREADS

Latest posts

Moderators online

Share this page

COMPANY
RESOURCES
FOLLOW
Top Bottom