Sign in with
Sign up | Sign in
Your question
Solved

Is it possible to fix a bent Power supply pin?

Last response: in Components
Share
January 29, 2014 3:20:51 PM

I got a Corsair CX600 600w power supply, but when I did the green+black wire test, I accidentally split the green wire pin on the ATX 24-pin. Will the power supply still work like this? Is there any way to fix?

January 29, 2014 3:32:10 PM

If you look closely in the picture, you can see that one of the connectors are split
m
0
l

Best solution

a c 272 ) Power supply
January 29, 2014 4:08:44 PM

Get yourself a pair of needle nosed pliers or something thin enough to get in on each side and give it a bit of a squeeze, all the connectors are split on top, that one just separated at bit. If you push it together so the top two bits touch it should work just fine. I think in its present state it would bind going into the main ATX connector on the board.
Share
January 29, 2014 4:16:33 PM

Charlie Pawlak said:
If you look closely in the picture, you can see that one of the connectors are split


hunter315 said:
Get yourself a pair of needle nosed pliers or something thin enough to get in on each side and give it a bit of a squeeze, all the connectors are split on top, that one just separated at bit. If you push it together so the top two bits touch it should work just fine. I think in its present state it would bind going into the main ATX connector on the board.


Thanks man!
m
0
l
!