Hi there,
As the title suggests, I need to replace the 200mm Big Boy Fan on my Antec Nine Hundred case. (Non-USB 3.0 for what matters)
My question is, how do I actually get to it? I've searched countless forums and websites, including Antec's, but all they have is a blown out mechanical drawing, and haven't been able to find a concrete answer as to how to get to it.
I've tried taking it apart once, but got frustrated and put it back together after worrying I messed up the ground screw.
From what I've gathered, I need to:
Before I go and try that, I'd just like to know if those are the correct steps or if there's a right way to do it. If possible, a step by step, well instructed, set of instructions would be great.
Thanks
As the title suggests, I need to replace the 200mm Big Boy Fan on my Antec Nine Hundred case. (Non-USB 3.0 for what matters)
My question is, how do I actually get to it? I've searched countless forums and websites, including Antec's, but all they have is a blown out mechanical drawing, and haven't been able to find a concrete answer as to how to get to it.
I've tried taking it apart once, but got frustrated and put it back together after worrying I messed up the ground screw.
From what I've gathered, I need to:
unscrew 4-8 screws near the fan, including the ground
supposedly unscrew the hard drive cage
remove the front face
and finally, push in the tabs to remove the top of the case to get to the fan
Before I go and try that, I'd just like to know if those are the correct steps or if there's a right way to do it. If possible, a step by step, well instructed, set of instructions would be great.
Thanks