I just ordered my 3rd GFX card and I cannot figure out what is going wrong.
Current config:
Asus Maximus VI Extreme
Intel 4770k i7
32 GB 1866 Corsair Dominator RAM
3X Asus GTX770 Direct CU GFX cards 3 way SLI bridge installed
(drivers installed 332.21)
1 DVI connected per card
Corsair Ax1200i Power supply
3x Dell 3008WFP Monitors all connected via DVI
I used to run 2 way SLI just fine but now I installed my 3rd card and I cannot get the settings to keep. I can run 3 way SLI on the "maximize 3d performance" setting all cards are showing activity during benchmarks. But when I choose "Span displays with Surround" the displays go blank blink a few times then just jumps back to the previous setting I chose.
Played around with the settings and config as much as I could. Have any ideas? It would be greatly appreciated!
Thank you,
Current config:
Asus Maximus VI Extreme
Intel 4770k i7
32 GB 1866 Corsair Dominator RAM
3X Asus GTX770 Direct CU GFX cards 3 way SLI bridge installed
(drivers installed 332.21)
1 DVI connected per card
Corsair Ax1200i Power supply
3x Dell 3008WFP Monitors all connected via DVI
I used to run 2 way SLI just fine but now I installed my 3rd card and I cannot get the settings to keep. I can run 3 way SLI on the "maximize 3d performance" setting all cards are showing activity during benchmarks. But when I choose "Span displays with Surround" the displays go blank blink a few times then just jumps back to the previous setting I chose.
Played around with the settings and config as much as I could. Have any ideas? It would be greatly appreciated!
Thank you,