Hello everyone, I recently finished my new build with an fx-8320 and used a tim called shin etsu g751 I left it to warm up in a bag with hot hot water because many have said that it's pretty hard to spread. I then applied a pea sized dot into the center if the cpu and ran prime95 immediately after to use the heat to help spread he paste. Does there seem to be any flaws with the method I used? Temps are at 60c on full load with a slightly over clocked to 3.7ghz though the cure time hasn't finished.
Did I apply this specific thermal paste correctly?
- Thread starter Trytiped
- Start date
Solution
ModernWarfare
Splendid
- Jan 26, 2014
- 3,114
- 0
- 23,560
thats a normal temp but it was better if you applied it in the middle of the cpu "pea sized" next time of you want to place it do it in the middle. wont make much difference most important that theres thermal paste applied not too much you're ok.
TRENDING THREADS
-
[SOLVED] Is it safe to use a recapped PSU for a long time ?- Started by zwtch_17
- Replies: 5
-
Question Laptop Crashing During Teams Calls or Video Editing in Premiere
- Started by bigdumbalski
- Replies: 1
-
Question User RX 580 8gb red devil powercolor, asking original BIOS- Started by PizzaInGame
- Replies: 7
-
News Microsoft updates Windows 11 24H2 requirements, CPU must support SSE4.2 or the OS will not boot- Started by Admin
- Replies: 19
-
Discussion What's your favourite video game you've been playing?- Started by amdfangirl
- Replies: 3K
Facebook
Twitter
Instagram