Problems with my computer sending signal to monitor

thetallguyoverthere · Feb 19, 2014

So I upgraded my PC last night and it's been one thing after another since then. Every time I boot the computer all the components will start up but it won't send any signal to the monitor (tried every port.) In order to get it to actually boot and send a signal I have to press the MemOk button next to the ram. After that everything will be good up until the computer goes to sleep. If I try to wake it, the fans and all start back up but I get no signal to the monitor and have to reboot and press the MemOk button again. It's a clean version of 7 that I installed today and I installed all the drivers this morning.

AMD 6800k Black Edition Processor
Asus A88X-Plus Motherboard
Gigabyte Gtx 770 OC GPU
G. Skill Ripjaw Ram 8gb x 2
Cooler Master 550w PSU

Any help would be greatly appreciated.

the great randini · Feb 19, 2014

go into bios and check the "primary graphics adapter" ensure it is set to pcie or autodetect, also you may need to adjust the timing of the ram.

If all else fails, try one stick of ram at a time, remove and reseat as well.

thetallguyoverthere · Feb 19, 2014

So the primary graphics adapter is set properly and I set the frequency of the ram to 1066 (I believe that is right for 2133 ram). I also tried one stick at a time and it was the same thing. I have found that I can get it to boot fine by shutting off the switch on the PSU and then turning back on though.

Search

Problems with my computer sending signal to monitor

thetallguyoverthere

Reputable

the great randini

Distinguished

thetallguyoverthere

Reputable

TRENDING THREADS

Latest posts

Moderators online

Share this page