I had to remove the heat sink a couple of times because I didn't screw it in properly, do I need to reapply thermal paste? Tags: Heat Thermal Compound Systems Last response: February 22, 2014 5:42 PM in Systems Share jay_gaz27 February 22, 2014 5:10:48 PM It wasn't screwing properly, and so I had to remove it a couple of times to get it right. Do I need to reapply again? It didn't dry off, it was still "wet". More about : remove heat sink couple times screw properly reapply thermal paste getochkn February 22, 2014 5:28:11 PM I reapply every time. m 0 l jay_gaz27 February 22, 2014 5:42:16 PM Hmm okay. I shall do that then as well. m 0 l Can't find your answer ? Ask ! Publish Read discussions in other Systems categories Homebuilt New Build Prebuilt Cases Power Supplies RAM CyberPower !
jay_gaz27 February 22, 2014 5:10:48 PM It wasn't screwing properly, and so I had to remove it a couple of times to get it right. Do I need to reapply again? It didn't dry off, it was still "wet". More about : remove heat sink couple times screw properly reapply thermal paste