Sign in with
Sign up | Sign in
Your question
Solved

Push Pull Fan Configuration

Tags:
  • Configuration
  • Fan
  • Components
Last response: in Components
Share
February 23, 2014 11:37:31 AM

In my upcoming build I am getting the H100i and I wanted to replace the fans.
I have heard a lot of different suggestions and numbers and I just wanted to make sure this setup would work or if it is overkill or what
I wanted to get two Nf-F12s in pull on the top of the rad and then two corsair sp120s in push on the bottom because in the case I'm getting you can't see above the rad but you can see below it so my question is, is this setup good enough, is it overkill or what? Also should I just get the Nf-F12s and run them in pull because from what I've seen push pull really isn't worth it.
Thanks!

More about : push pull fan configuration

Best solution

February 23, 2014 12:33:00 PM

That seems pretty overkill, most people just stick with a single set of fans. Having push-pull usually doesn't benefit higher overclocks, but you may see a reduction in temperatures vs single set. A single set of Noctuas should do the job
Share
February 23, 2014 12:36:24 PM

randomhkkid said:
That seems pretty overkill, most people just stick with a single set of fans. Having push-pull usually doesn't benefit higher overclocks, but you may see a reduction in temperatures vs single set. A single set of Noctuas should do the job


Thank you!
m
0
l
!