GTX 650 No Display After Installing Driver Software

Maxim Cryseria · Feb 24, 2014

Hi, so I recently purchased a Palit GTX 650 gpu. It works fine after I plugged in a 6 pin PCIE connector/supplementary cable. I get the low resolution screen when first booting it up and after I install the drivers and restart I get a no display notification on my LCD after the Windows splash screen. I already used the display driver uninstaller and ccleaner and also did a clean install while running the driver installer. I can tell that my motherboard has detected the card and that it's actually powered on cause the fan is spinning.

My current setup is:
Windows 7 64bit OS
Motherboard Acer FIH57
4Gbs/2pcs @Gbs ram
Generic PSU 700w w/ 6 pin pcie connector/supplementary cable
Palit GTX650

warezme · Feb 24, 2014

I misread your post your screen goes blank after the windows splash. Try going into safe mode and changing default screen resolution to a low resolution like 800x600 and see if that helps also make sure the frequency is set to a generic 60Hz. I once had a 660 do the same thing on a Dell and there was no fix for it unfortunately, had to send it back. It was either a bad card or the OEM had decided to not allow 3rd party cards. I have never run into another issue like that before.

wimpywolf · Aug 5, 2014

warezme :

I have the same issue as Maxim but my card (MSI 650) doesn't even output the bios options. It used to work before this recent driver update. My MOBO's onboard graphics aren't working even after the card is out EVEN if i clear CMOS!!!

Search

GTX 650 No Display After Installing Driver Software

Maxim Cryseria

Reputable

warezme

Distinguished

wimpywolf

Honorable

TRENDING THREADS

Latest posts

Moderators online

Share this page