Hello,
I wanted to OC my i2500k and my hardware store recommended the Zalman CNPS7X LED. They installed it but when i got home and ran some IntelBurn tests i got this:
40x multiplier(4Ghz) will start to go over 80 degrees C in the 1st test if its set at maximum(out of 10, i was told to test it 10 times) If i set it at standard it can do 10 tests with the temp touching 80 for a few seconds.
I stopped testing because as far as i know its a bad idea to go over 80...
Did they give me poor advice or did they not install it properly?
I was a bit disappointing i even told them that i could go higher on the price... they said its enough and that it will work.
I`m planning to call them tomorrow but i wanted to make sure i`m testing it right.
I wanted to OC my i2500k and my hardware store recommended the Zalman CNPS7X LED. They installed it but when i got home and ran some IntelBurn tests i got this:
40x multiplier(4Ghz) will start to go over 80 degrees C in the 1st test if its set at maximum(out of 10, i was told to test it 10 times) If i set it at standard it can do 10 tests with the temp touching 80 for a few seconds.
I stopped testing because as far as i know its a bad idea to go over 80...
Did they give me poor advice or did they not install it properly?
I was a bit disappointing i even told them that i could go higher on the price... they said its enough and that it will work.
I`m planning to call them tomorrow but i wanted to make sure i`m testing it right.
Facebook
Twitter
Instagram