Sign in with
Sign up | Sign in
Your question

Monitor turns on but it goes black after the Windows 7 start up screen and then all I see is a cursor. But its working fine in

Last response: in Graphics & Displays
Share
March 21, 2014 11:29:18 PM

Monitor turns on but it goes black after the Windows 7 start up screen and then all I see is a cursor. But its working fine in "safe mode with Networking". Please help!!!. Any luck that I can fix this problem using the safemode?
March 21, 2014 11:49:09 PM

Thank you very much for the prompt response, I will give a try to the suggested solution and let you know.
m
0
l
Related resources
March 22, 2014 12:19:33 AM

I got something like this when i Run SFC /Scannow to Repair.
----------------------------
Microsoft Windows [Version 6.1.7600]
Copyright (c) 2009 Microsoft Corporation. All rights reserved.

C:\Windows\system32>sfc /scannow

Beginning system scan. This process will take some time.

Beginning verification phase of system scan.
Verification 100% complete.

Windows Resource Protection did not find any integrity violations.

C:\Windows\system32>
----------------------------

Should I go ahead and restart and check? but i think as its not repaired anything it will not fix the issue.
m
0
l
March 22, 2014 12:01:53 PM

Start Repair solved the problem...
A guide to Startup Repair
So, your computer's been infected or the storage has been damaged in some way, which causes the computer to only be able to boot into BIOS, and this annoying little GUI: So, I'm here to show you how to fix this. Sadly, the most practical way of... See full content
m
0
l
March 22, 2014 12:02:29 PM

Thanks Everyone for your help :) 
m
0
l
!