you can try this, you may be able to overclock it to 3.5
Robust Graphics Booster___________ [Auto or fast]
CPU Clock Ratio ____________ [10]
Fine Clock Ratio ____________[0.5]
CPU Host Clock Control_ [Enabled]
CPU Host Frequency (MHz)__________ [333]
PCI Express Frequency (Mhz)_______ [100]
C.I.A. 2__________________________ [Disabled]
System Memory Multiplier (SPD)____ [2.40B]
DRAM Timing Selectable_______ SPD __ [Manual]
Performance Enhance = [Standard]
CAS Latency Time________________ 5
Dram RAS# to CAS# Delay_________ 5
Dram RAS# Precharge Delay_______5
Precharge Delay (tRAS)__________ 15
ACT to ACT Delay (tRRD)_________ 3-4
Rank Write to READ Delay________ 3-6
Write to Precharge Delay_________ 4-6
Refresh to ACT Delay______________ 52-62
Read to Precharge Delay__________3-5
Static tRead Value_______________ 7-10
Static tRead Phase Adjust________ [Auto] << Always Auto
System Voltage Control____ [Manual]
DDR2 OverVoltage Control__ [+0.100V] =1.9
PCI-E OverVoltage Control_ [+0.1V]
FSB OverVoltage Control___ [+0.1V]
(G)MCH OverVoltage Control [+0.2V]
CPU Voltage Control_______ [1.38] << you may need more, or less, but just set high for now you can lower later. And do keep in mind what you set here will be less in windows at idle, and less then that under full load.
Limit CPUID Max. to 3.....................: [Disabled]
No-Execute Memory Protect............: [Enabled]
CPU Enhanced Halt (C1E)................: [Disabled]
C2/C2E State Support....................: [Disabled]
x C4/C4E State Support..................: [Disabled]
CPU Thermal Monitor 2(TM2) ...........: [Enabled]
CPU EIST Function.........................: [Disabled]
Virtualization Technology................: [Disabled] Enabled if you use Vmware/Virtual PC
Integrated Peripherals
Legacy USB Storage Detect___________________[Disabled] *Note* Must be enabled to flash from USB