Solved Whenever I try to access my router by putting my default gateway in for a URL, it just says it couldn't find the page... Tags: halp Networking Routers Wireless Default Gateway Modem Last response: April 7, 2014 7:43 AM in Networking Share pinapplezrkool April 5, 2014 3:45:09 PM Accessing router through default gateway? More about : access router putting default gateway url find page Reply to pinapplezrkool Best solution DavidBerger1 April 7, 2014 4:35:11 AM Press Ctrl+R type in: cmd then on the Command Promt type: ipconfig it should give a couple of parameters, locate "Default Gateway" and type it's IP Adress on your Browser. P.S. You will need to know the Username and Password of your Router. In most cases the IP Address is: 192.168.0.1 192.168.1.254 192.168.1.100 192.168.1.1 Reply to DavidBerger1 Share hang-the-9 a b F Wireless April 7, 2014 7:43:07 AM pinapplezrkool said:Accessing router through default gateway? You have no connection to the router or it's bad. Did you try rebooting the router and computer? How are you trying to access it, wireless or wired? Try different ports? Make sure the cables are in properly or try a new cable? Reply to hang-the-9 m 0 l Ask the community Post an answer Read discussions in other Networking categories Routers Gateways VPN LAN WAN Firewalls Cisco Netgear !